Introduction of blocks

LU blocks

Red

Yellow

Gray

Black

Blue

Green

TU blocks

Red

Yellow

Gray

Black

Blue

Green

HU blocks

Red

Yellow

Gray

Black

Blue

Green

SU blocks

Red

Yellow

Gray

Black

Blue

LD blocks

Red

Blue

White

Black

FC blocks

Red

Blue

Black

Other

DC

LW

BT

BY

BU

WH

DR

LT Blue

LT Red

LT Black

ST

TW

IB Blue

Assembly tips

1

This is how to separate the locking unit (or hollow unit).
The component may not separate properly if you try to do it by holding the center of Block No. 2 as shown in Image A.
As shown in Image B, hold an edge of Block No. 2 and bend the connected blocks to separate them.
If only Blocks No. 1 and 2 remain as shown in Image C, hold the farthest edge of Block 2 and bend it to separate them easily.

2

Is it difficult to hold the lateral pin while separating it from the hollow unit?
As shown in Image B, connect another hollow unit to the lateral pin to hold and separate it more easily.

3

This is how to remove a small tip from a drum.

Press the small tip inserted into the drum with the locking unit (or hollow unit) as shown in Image A,
and the end of the small tip will protrude slightly.
Hold the protruding small tip and separate it from the drum.

4

Once you connect the wheel to the drum, use it as is without separating them.
The wheel may break, or you may injure your hand while separating the wheel from the drum.
Use the assembled wheel as it is.

5

When using bracket units, bracket tips, or bracket yokes to create a model, assemble them first.
It may be more difficult to connect other blocks if you don’t connect all the bracket units,
bracket tips, and bracket yokes first as shown in Image A.
As shown in Image B, assemble the bracket units, bracket tips, or bracket yokes first,
and then connect the other blocks. It will be much easier.

6

It is difficult to remove manually the hollow unit (or locking unit) connected to a long locking unit.

As shown in Image B, press the side of the long locking unit using another hollow unit (or Locking Unit A).